TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Mac's River Runner VS Rock Hopper
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="onthewater102" data-source="post: 345344" data-attributes="member: 13702"><p>I was thinking about making something similar to the river runner from stainless plate...I'm fairly good with my MIG welder - anything special about it that might make that difficult? It looks like I'd have to start with uncut pieces bolted to the sides of the skeg & then mark off where to cut to line everything else up off of those positions - but that sounds too easy for something that retails for $130+</p></blockquote><p></p>
[QUOTE="onthewater102, post: 345344, member: 13702"] I was thinking about making something similar to the river runner from stainless plate...I'm fairly good with my MIG welder - anything special about it that might make that difficult? It looks like I'd have to start with uncut pieces bolted to the sides of the skeg & then mark off where to cut to line everything else up off of those positions - but that sounds too easy for something that retails for $130+ [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Mac's River Runner VS Rock Hopper
Top