TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
mid to late 60's 9,9 sea horse
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="kooldecker" data-source="post: 466240" data-attributes="member: 22464"><p>pappy this question is for you. i started to break down the lower unit to replace the water pump/impeller. first thing i noticeced upon draining the oil was water. but as went further the a absence of ANY seal for the lower instantly answered that problem. </p><p> now as i got into the lower , i noticed the new omc kit contains two seals. one for under the plate, and im not sure where the other goes . however....when i look up into the shaft housing....i see where the drive shaft goes and it sure looks like the other seal should go there. it looks like its the same diameter and the seal , and just makes sense to have one there.....but there isnt one presently (hey old owner could have botched it easily im sure) ive included a picture of the tube in question. what are your thoughts ?</p></blockquote><p></p>
[QUOTE="kooldecker, post: 466240, member: 22464"] pappy this question is for you. i started to break down the lower unit to replace the water pump/impeller. first thing i noticeced upon draining the oil was water. but as went further the a absence of ANY seal for the lower instantly answered that problem. now as i got into the lower , i noticed the new omc kit contains two seals. one for under the plate, and im not sure where the other goes . however....when i look up into the shaft housing....i see where the drive shaft goes and it sure looks like the other seal should go there. it looks like its the same diameter and the seal , and just makes sense to have one there.....but there isnt one presently (hey old owner could have botched it easily im sure) ive included a picture of the tube in question. what are your thoughts ? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
mid to late 60's 9,9 sea horse
Top