TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
New intake assembly
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="1gr8bldr" data-source="post: 479795" data-attributes="member: 25704"><p>I purchased the urethane foot from Wolldridge. I have not installed it yet but I will report the progress. I expect it to speed up, not because of the Urethane foot but rather a new liner that is gouged badly. However, it is 17 years old. So you could expect such. My foot is not trash yet but it's been welded once and the heel pin area is ground down to the point that it could come out soon. I could not remove it to replace the fins. I expect I can remove it by cutting the pin into sections and driving it out. I will renew and keep it for a spare. I figure I got good life from this foot so one may wonder why I would try the urethane foot? I purchased it in hope to reduce the hit the hull takes when the heel hits. Flex is what i was assuming it might do. After looking at it, I'm not sure it will flex?</p></blockquote><p></p>
[QUOTE="1gr8bldr, post: 479795, member: 25704"] I purchased the urethane foot from Wolldridge. I have not installed it yet but I will report the progress. I expect it to speed up, not because of the Urethane foot but rather a new liner that is gouged badly. However, it is 17 years old. So you could expect such. My foot is not trash yet but it's been welded once and the heel pin area is ground down to the point that it could come out soon. I could not remove it to replace the fins. I expect I can remove it by cutting the pin into sections and driving it out. I will renew and keep it for a spare. I figure I got good life from this foot so one may wonder why I would try the urethane foot? I purchased it in hope to reduce the hit the hull takes when the heel hits. Flex is what i was assuming it might do. After looking at it, I'm not sure it will flex? [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
New intake assembly
Top