TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
New Jet Motor advice for 16’ Xpress
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Scott F" data-source="post: 471473" data-attributes="member: 23059"><p>My boat was designed for a jet. No tunnel, but the transom is taller in the center instead of straight across. I had that motor on a different boat when it was a tiller and it needed a jack plate to raise the motor a few inches to the correct height. Power tilt will change the angle of the intake foot which won’t help if the motor wasn’t installed at the right height. Power trim will help you remove weeds when you plug up the intake. Minor changes in tilt might help reduce splashing.</p></blockquote><p></p>
[QUOTE="Scott F, post: 471473, member: 23059"] My boat was designed for a jet. No tunnel, but the transom is taller in the center instead of straight across. I had that motor on a different boat when it was a tiller and it needed a jack plate to raise the motor a few inches to the correct height. Power tilt will change the angle of the intake foot which won’t help if the motor wasn’t installed at the right height. Power trim will help you remove weeds when you plug up the intake. Minor changes in tilt might help reduce splashing. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
New Jet Motor advice for 16’ Xpress
Top