TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
NS 9.9b cooling water check port
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="DaleH" data-source="post: 478574" data-attributes="member: 15636"><p>Once you get it running well enough to 'run it a while', I'd take a can of Seafoam, and enough gas to make a 1-gallon mix, but add 'extra' TC-W3 oil than just what's needed for the 1-gallon (go a little heavy on the oil amount) and mix well.</p><p></p><p>Then run it in the water or in a barrel (NOT on muffs!) at high idle for 10-minutes at a time, then shutoff for 15-mins. Repeat, repeat, repeat ... even over a few days, so this is where a large plastic barrel is handy. If in the water, you can put it in gear & throttle up/down some too. That should clean her out and decarb the motor at the same time.</p></blockquote><p></p>
[QUOTE="DaleH, post: 478574, member: 15636"] Once you get it running well enough to 'run it a while', I'd take a can of Seafoam, and enough gas to make a 1-gallon mix, but add 'extra' TC-W3 oil than just what's needed for the 1-gallon (go a little heavy on the oil amount) and mix well. Then run it in the water or in a barrel (NOT on muffs!) at high idle for 10-minutes at a time, then shutoff for 15-mins. Repeat, repeat, repeat ... even over a few days, so this is where a large plastic barrel is handy. If in the water, you can put it in gear & throttle up/down some too. That should clean her out and decarb the motor at the same time. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
NS 9.9b cooling water check port
Top