TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Open 16ft starcraft SS with tiller?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="g0nef1sshn" data-source="post: 388822" data-attributes="member: 16085"><p>Got some work done today before dropping her off tomorrow for the transom cap. 6 more total bolts through the transom. 4 holes were already there (4 white smeared bolts below aluminum rectangles). Then I drilled a hole between each of the 4 old drains for the splashwell (2 new holes to cover 4). 5200'd those pates on and bolted center covered them pretty nicely. There were 5 more 1/4 inch holes in the transom skin so I filled those with a little JB weld. It will get all cleaned up once I have it back. Added plates both sides because those two below them started sinking into the wood and I didnt like that feeling. I aslo put 1 inch SS lag screws in the z brace. I didnt 5200 on the inside, but I did bead the top with it to help keep water out. I know I make a mess of that stuff.</p></blockquote><p></p>
[QUOTE="g0nef1sshn, post: 388822, member: 16085"] Got some work done today before dropping her off tomorrow for the transom cap. 6 more total bolts through the transom. 4 holes were already there (4 white smeared bolts below aluminum rectangles). Then I drilled a hole between each of the 4 old drains for the splashwell (2 new holes to cover 4). 5200'd those pates on and bolted center covered them pretty nicely. There were 5 more 1/4 inch holes in the transom skin so I filled those with a little JB weld. It will get all cleaned up once I have it back. Added plates both sides because those two below them started sinking into the wood and I didnt like that feeling. I aslo put 1 inch SS lag screws in the z brace. I didnt 5200 on the inside, but I did bead the top with it to help keep water out. I know I make a mess of that stuff. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Open 16ft starcraft SS with tiller?
Top