TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Painting my Motor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="CedarRiverScooter" data-source="post: 426457" data-attributes="member: 15465"><p>Temperature is very important when you spray, 75 deg F is optimum, colder & it wants to run. Too hot & it orange peels.</p><p></p><p>Practice making a spray pattern on some cardboard before painting the motor.</p><p></p><p>I was taught to cover the border 1st, then go back & fill in the middle. </p><p></p><p>Use a good fresh respirator & goggles.</p><p></p><p>I would just mask off the steering gimbal area, it just gets greasy again anyway.</p></blockquote><p></p>
[QUOTE="CedarRiverScooter, post: 426457, member: 15465"] Temperature is very important when you spray, 75 deg F is optimum, colder & it wants to run. Too hot & it orange peels. Practice making a spray pattern on some cardboard before painting the motor. I was taught to cover the border 1st, then go back & fill in the middle. Use a good fresh respirator & goggles. I would just mask off the steering gimbal area, it just gets greasy again anyway. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Painting my Motor
Top