TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Picked up a SeaArk 1652...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="handyandy" data-source="post: 461405" data-attributes="member: 18942"><p>24-26mph would be my guess if it were a straight flat bottom a little faster. It may be a little bit better, but it's hard to get much over 30 out of a 60/40 unless it's on a pretty light flat bottom boat. Some guys go faster with the old two strokes, but they have usually modded them, and have them on lighter flat bottom hulls like a blazer. SEMO guys are big on 60/40's cause of hp restriction on some mo rivers. Pods do help with getting up on plane faster, you might have to dig for it but not too long ago I did full write up in the outboard jet section about my pod installation. I'm happy with them boat planes out quicker, with a heavier load is where I can really tell they made a difference. Drafts a good few inches less now too.</p></blockquote><p></p>
[QUOTE="handyandy, post: 461405, member: 18942"] 24-26mph would be my guess if it were a straight flat bottom a little faster. It may be a little bit better, but it's hard to get much over 30 out of a 60/40 unless it's on a pretty light flat bottom boat. Some guys go faster with the old two strokes, but they have usually modded them, and have them on lighter flat bottom hulls like a blazer. SEMO guys are big on 60/40's cause of hp restriction on some mo rivers. Pods do help with getting up on plane faster, you might have to dig for it but not too long ago I did full write up in the outboard jet section about my pod installation. I'm happy with them boat planes out quicker, with a heavier load is where I can really tell they made a difference. Drafts a good few inches less now too. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Picked up a SeaArk 1652...
Top