TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Poly/UHMW intake fins?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="handyandy" data-source="post: 428563" data-attributes="member: 18942"><p>I have the UHMW intake and fins I don't always run them. Depends on what I'm doing. The UHMW intake is well made did slow me down some not a lot. I like the fins they haven't taken any good hits yet. I'll try and take pics of the fins and intake to show how they are. I do want to come up with a better way to mount the fins the threaded rod from james river jets is crap. I may have to call obj and get their rods and maybe make plate that disperses the clamping force of the nuts tightening down on the fins. What would be awesome is if rock proof made their intake with fins so it was one uhmw piece with fins. I like the fins cause I can run my motor a little higher out of harms way.</p></blockquote><p></p>
[QUOTE="handyandy, post: 428563, member: 18942"] I have the UHMW intake and fins I don't always run them. Depends on what I'm doing. The UHMW intake is well made did slow me down some not a lot. I like the fins they haven't taken any good hits yet. I'll try and take pics of the fins and intake to show how they are. I do want to come up with a better way to mount the fins the threaded rod from james river jets is crap. I may have to call obj and get their rods and maybe make plate that disperses the clamping force of the nuts tightening down on the fins. What would be awesome is if rock proof made their intake with fins so it was one uhmw piece with fins. I like the fins cause I can run my motor a little higher out of harms way. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Poly/UHMW intake fins?
Top