TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Poly/UHMW intake fins?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="LarryMc" data-source="post: 428590" data-attributes="member: 13895"><p>A place called Top Notch Machining used to make them. I bought one back in early 2014. Best I can recall it cost me around $350 plus shipping. It lasted about 15 minutes on my boat. I hit a submerged tree and it ripped the fin on one side about halfway off. If it had been an aluminum intake it wouldn't even have been damaged. They were good enough to refund my money, less shipping of course. They must of gotten a lot of complaints because soon after that, they started recommending that they not be installed on non-tunnel boats. They have stopped making them completely now. I don't have any pictures of the intake before I hit the tree, but I do have a couple of "after" pics.</p></blockquote><p></p>
[QUOTE="LarryMc, post: 428590, member: 13895"] A place called Top Notch Machining used to make them. I bought one back in early 2014. Best I can recall it cost me around $350 plus shipping. It lasted about 15 minutes on my boat. I hit a submerged tree and it ripped the fin on one side about halfway off. If it had been an aluminum intake it wouldn't even have been damaged. They were good enough to refund my money, less shipping of course. They must of gotten a lot of complaints because soon after that, they started recommending that they not be installed on non-tunnel boats. They have stopped making them completely now. I don't have any pictures of the intake before I hit the tree, but I do have a couple of "after" pics. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Poly/UHMW intake fins?
Top