TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Source for SS Finish Washers to secure vinyl flooring & trim
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="DaleH" data-source="post: 386061" data-attributes="member: 15636"><p>Source = https://www.clipsandfasteners.com/Finishing_s/206.htm</p><p></p><p>Note the special shape of these washers, vs. the typical counter-sunk ones with a hard/sharp edge that would cut through the vinyl flooring. These trim washers have a small flat or rim flange on the extreme OD to grip the material and hold it ... without cutting it. </p><p></p><p><strong>NOTE</strong> that in use. most boat manufacturers use <strong>2 washers per fastener, not 1</strong>. They do stack together nicely and one wouldn't know there was really 2 there until you took them apart. The bottom washer grips the material while the top one can spin, if needed, to take the torque from affixing the fastener. In this way you don’t cause the material to twist or pull, but lay flat. </p><p></p><p>I needed some for my present rebuild and though others might be interested in them too.</p><p></p><p>Cheers!</p></blockquote><p></p>
[QUOTE="DaleH, post: 386061, member: 15636"] Source = https://www.clipsandfasteners.com/Finishing_s/206.htm Note the special shape of these washers, vs. the typical counter-sunk ones with a hard/sharp edge that would cut through the vinyl flooring. These trim washers have a small flat or rim flange on the extreme OD to grip the material and hold it ... without cutting it. [b]NOTE[/b] that in use. most boat manufacturers use [b]2 washers per fastener, not 1[/b]. They do stack together nicely and one wouldn't know there was really 2 there until you took them apart. The bottom washer grips the material while the top one can spin, if needed, to take the torque from affixing the fastener. In this way you don’t cause the material to twist or pull, but lay flat. I needed some for my present rebuild and though others might be interested in them too. Cheers! [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Source for SS Finish Washers to secure vinyl flooring & trim
Top