TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
thru hull pump questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bigwave" data-source="post: 309920" data-attributes="member: 7537"><p>There are a few options.....you could remove the thru-hull and have someone weld the hole shut..sand,prime,paint and your done. or you could do as the above poster stated and buy a new thur-hull and plug with drian plug. If you install a new thur-hull you could also add a ball valve and have a water intake source for future live-well, if you choose. The part that is attached to the inside of the transom should be threaded on the existing thru-hull and should screw off if the PO did not 5200 it on. Plastic thru-hulls are cheap, so as a last resort break it off and replace with new thru-hull and drain plug. From the pic it looks like that pump was installed a bit high to me.</p></blockquote><p></p>
[QUOTE="bigwave, post: 309920, member: 7537"] There are a few options.....you could remove the thru-hull and have someone weld the hole shut..sand,prime,paint and your done. or you could do as the above poster stated and buy a new thur-hull and plug with drian plug. If you install a new thur-hull you could also add a ball valve and have a water intake source for future live-well, if you choose. The part that is attached to the inside of the transom should be threaded on the existing thru-hull and should screw off if the PO did not 5200 it on. Plastic thru-hulls are cheap, so as a last resort break it off and replace with new thru-hull and drain plug. From the pic it looks like that pump was installed a bit high to me. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
thru hull pump questions
Top