TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Tilt setting in between
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Pappy" data-source="post: 353283" data-attributes="member: 3278"><p>Adding pitch to a blade and adding cup to a blade are two entirely different operations. Adding pitch can be rough on an aluminum blade however adding cup to the blade....not so much. </p><p>The cost is less than half the cost of a new propeller or less to have this done. We send props off every Monday and Thursday. Have never seen costs go past this. Usually less unless a new hub is required. If a hub is needed plus blade repair it normally runs about half the cost of new.</p></blockquote><p></p>
[QUOTE="Pappy, post: 353283, member: 3278"] Adding pitch to a blade and adding cup to a blade are two entirely different operations. Adding pitch can be rough on an aluminum blade however adding cup to the blade....not so much. The cost is less than half the cost of a new propeller or less to have this done. We send props off every Monday and Thursday. Have never seen costs go past this. Usually less unless a new hub is required. If a hub is needed plus blade repair it normally runs about half the cost of new. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Tilt setting in between
Top