TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Tracker Tournament TX Rebuild
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Bobsbaits" data-source="post: 342794" data-attributes="member: 12589"><p>Did some work over the weekend and figured I would catch up the pictures here. Finished the rod box, except for the lid. The starboard worked real nice. I also framed out the front battery compartment and cooler area. Lot's of time spent, but it doesn't look like a lot done for all the time. I also cut out the front deck and added a recessed foot pedal tray. I really like how these work. I took the old wiring harness and cleaned it up. There were wires cut off in the middle and there was old trolling motor wires that were too thin for anything other than 12 volt. After I cleaned it up I rewrapped it and ran it threw the boat. I see I screwed up and should have ran the harness before I attached the driver side panel, whoops. Now I'll have to figure a clean way to cover the harness. Next weekend I hope to cut the top over the battery area and do some wiring. Before I put the front panel back on, I added some pour foam in to replace what I took out.</p></blockquote><p></p>
[QUOTE="Bobsbaits, post: 342794, member: 12589"] Did some work over the weekend and figured I would catch up the pictures here. Finished the rod box, except for the lid. The starboard worked real nice. I also framed out the front battery compartment and cooler area. Lot's of time spent, but it doesn't look like a lot done for all the time. I also cut out the front deck and added a recessed foot pedal tray. I really like how these work. I took the old wiring harness and cleaned it up. There were wires cut off in the middle and there was old trolling motor wires that were too thin for anything other than 12 volt. After I cleaned it up I rewrapped it and ran it threw the boat. I see I screwed up and should have ran the harness before I attached the driver side panel, whoops. Now I'll have to figure a clean way to cover the harness. Next weekend I hope to cut the top over the battery area and do some wiring. Before I put the front panel back on, I added some pour foam in to replace what I took out. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Tracker Tournament TX Rebuild
Top