TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
What shaft length jet would work best on my Lowe 1652 VT?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BigTerp" data-source="post: 335224" data-attributes="member: 9169"><p>Sounds good. Since your hull is tunnelled, I'm guessing you'll have to raise your transom even with a short shaft motor to get your motor at the optimal height. I don't think you'll be able to use your Mercury cables with an OMC controller. For one, the cable ends will be different (not sure if you can swap those out) and I'm also not sure how the wiring would work from an OMC controller to a Mercury motor. There may be some conversion kits or something you could get though. I have a set of Mercury cables that won't work with my '94 Johnson and OMC control box. I hear you on the cold!! I have a set pair of HID converted driving lights I need to install, but we had a high of 26 yesterday and this morning it was 11 degrees. Waiting for a little bit of a warmer day before I tackle that job.</p></blockquote><p></p>
[QUOTE="BigTerp, post: 335224, member: 9169"] Sounds good. Since your hull is tunnelled, I'm guessing you'll have to raise your transom even with a short shaft motor to get your motor at the optimal height. I don't think you'll be able to use your Mercury cables with an OMC controller. For one, the cable ends will be different (not sure if you can swap those out) and I'm also not sure how the wiring would work from an OMC controller to a Mercury motor. There may be some conversion kits or something you could get though. I have a set of Mercury cables that won't work with my '94 Johnson and OMC control box. I hear you on the cold!! I have a set pair of HID converted driving lights I need to install, but we had a high of 26 yesterday and this morning it was 11 degrees. Waiting for a little bit of a warmer day before I tackle that job. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
What shaft length jet would work best on my Lowe 1652 VT?
Top