Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
This is the running list of the current Sponsors. Help support TinBoats.net by supporting these guys first if you are shopping for similar products....
Read a bunch about this product and decided it was something I wanted to do. Pulled the trigger last week and ordered the 3 layer system for boats up...
Last post
It stays on the hull fine. If you hit a large rock or concrete it's going to scrape off but sand or gravel doesn't seem to affect it
Any one hear anything on the new 60/40 etec? Looks to be 247lb, I'm guessing medium pump.
Last post
Yeah looks like the large pump. Wonder how this engine would compare with the Merc 60/40 4S. I feel like the E-TEC would have better performance all...
I have a dent or two in my Tracker 1648 hull bottom that I'm pretty sure is effecting my performance. Loosing about 5 mph at WOT. Previously with my...
Last post
Yeah, it's stainless.
Not much gained by shimming down and cleaning up the impeller. Hole shot was slightly better. Top end about the same. 19-20 up...
I've run the boat for the last 3 seasons without really worrying about the impeller or liner because I remember looking at both when I straightened...
Last post
i HATE the studs that came with mine. took them out and replaced with stainless bolts. Everytime I hit something and then later needed to remove the...
Who has any experience with mid to late '90s Evinrude jet? Looking at one to repower my tin. Reliability, performance, reliability, ease of maint and...
Last post
The two cylinder and three cylinder omc (evinrude/johnson) engines were some of the best two stroke engines. I'm partial to omc though, but if you...
Hey fellas, just wondering what you guys think about a 2007 Mercury 4 stroke EFI. I have always had 2 stroke carbed motors and can fix em as good as...
Last post
Thanks for the input. I am very happy with mine so far. Just did spark plugs, timing belt, valve adjustment, oil change. I suspect that I need to do...
Okay guys, so I was wondering, how in the world are you all getting the big brass nut that holds the jet impeller off? In the manual it tells you to...
Hey everyone. I bought my boat last November it has a mercury 30jet. The first dozen times out it ran very well.. but the last few times out it spits...
Last post
Okay so today I removed oil tank, plugged the line, and now the motor will start instantly. The only thing I need to do now is remove the shafts and...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum