PhilG
Member
- Joined
- Jan 13, 2010
- Messages
- 9
- Reaction score
- 0
wait..it wasn't snow. it was foam from the bench seat being gutted for a livewell. That $%^ went everywhere!!
The forum gave me the confidence to break out the jig saw - which wouldn't cut, just kept pulling out the blade - and then the cutoff well on a 4" grinder. Got the opening and bench area cleaned out awaiting livewell from FishMatePro.
For foam removal I used a serrated knife and a wood chisel. Finally got a pattern down and took about an hour and half to get it out. The cleanup however took MUCH longer. Looked like a blizzard!
Again, I would have never done this without all of the pics, information and encouragement from TinBoats. Cheers!
phil
The forum gave me the confidence to break out the jig saw - which wouldn't cut, just kept pulling out the blade - and then the cutoff well on a 4" grinder. Got the opening and bench area cleaned out awaiting livewell from FishMatePro.
For foam removal I used a serrated knife and a wood chisel. Finally got a pattern down and took about an hour and half to get it out. The cleanup however took MUCH longer. Looked like a blizzard!
Again, I would have never done this without all of the pics, information and encouragement from TinBoats. Cheers!
phil