mychelle1983
New member
- Joined
- Feb 8, 2010
- Messages
- 2
- Reaction score
- 0
have several rivet and small bolt holes in alum. boat.suggestions on products to use to fill holes and that can be sanded & painted-thanks
TinBoats.net
The original aluminum boat site!
rivet holes
- Thread starter mychelle1983
- Start date
Help Support TinBoats.net:
beetlespin
Well-known member
mychelle1983 said:
why not just put a rivet in them?
russ010
Well-known member
i would put rivets back in them too...
but, they make a stick type of epoxy that you cut off, roll up in your fingers and form in and around the hole. Once it has cured, you can sand it down and paint it
https://www.westmarine.com/webapp/w...8?&cid=chanintel&ci_src=14110944&ci_sku=81628
but, they make a stick type of epoxy that you cut off, roll up in your fingers and form in and around the hole. Once it has cured, you can sand it down and paint it
https://www.westmarine.com/webapp/w...8?&cid=chanintel&ci_src=14110944&ci_sku=81628
Truckmechanic
Well-known member
I would go with Rivits also.
mychelle1983
New member
- Joined
- Feb 8, 2010
- Messages
- 2
- Reaction score
- 0
i am going to paint boat and just wanted it to look good.GUESS i could put rivets back in
damifinowfish
Well-known member
- Joined
- Jan 21, 2010
- Messages
- 45
- Reaction score
- 0
russ010 said:
Why not use jb weld at 1/2 the price?
MeanMouth
Well-known member
I would do rivets, or hts-2000 brazing rods.
Similar threads
