begs
Well-known member
Ok so I got a 1957 35hp evinrude is it possible that they made a 14' boat that will take a 35hp, if not is it possible to brace a transom to accept a 35hp?
TinBoats.net
The original aluminum boat site!
Have a motor, need a boat?
- Thread starter begs
- Start date
Help Support TinBoats.net:
lckstckn2smknbrls
Well-known member
- Joined
- Oct 5, 2008
- Messages
- 4,852
- Reaction score
- 172
- LOCATION
- Lake in the Hills Illinois
A couple of days ago there was a 14' boat rated for 35hp on CL No Ill.
It was listed on thursday 5-5-10 in park ridge.
It was listed on thursday 5-5-10 in park ridge.
Yep. An older Alumacraft T14XL.
I had one up until a few months ago ('85 model) that was rated for 35. If I'm not mistaken, the pre '85 (when the outboard rating system changed - actual capacity remained the same) were rated for 40.
I had one up until a few months ago ('85 model) that was rated for 35. If I'm not mistaken, the pre '85 (when the outboard rating system changed - actual capacity remained the same) were rated for 40.
begs
Well-known member
OK I found a 16' boat but it is for a short shaft motor. Would I be able to set this up for a long shaft motor????
lckstckn2smknbrls
Well-known member
- Joined
- Oct 5, 2008
- Messages
- 4,852
- Reaction score
- 172
- LOCATION
- Lake in the Hills Illinois
Look at jack plates or motor raisers. I have a TH Marine mini jack plate.
