Flatsdaddy
Well-known member
How hard should it be to push my motor down when it is trimmed up? It will not stay in place when trimmed up to run shallow and I can push it down with my hand. I'm thinking it should be harder to move than this.
TinBoats.net
The original aluminum boat site!
Tilt and trim question
- Thread starter Flatsdaddy
- Start date
Help Support TinBoats.net:
redbug
Well-known member
it shouldn't move at all unless you are trimming it down
it sounds like ou have a bad seal in the trim unit
it sounds like ou have a bad seal in the trim unit
huntinfool
Well-known member
Thisredbug said:
