alfaguy
Active member
- Joined
- Sep 10, 2011
- Messages
- 25
- Reaction score
- 0
I finished fabrication and mounting my version of an adjustable jackplate on my 14 ft Rhino today, and thought I would share the design with the group. It was built using the Bob Dillion Racing plans, but I needed it to be adjustable from a single point, so I adapted the Vance Engineering type adjuster, but using a 1/2 inch x 8 inch long piece of all thread. I used 4x4x1/4 angle for the boat attachment part, and 3x3x1/4 angle for the motor portion.
With the motor board I have a 6 inch setback and it will adjust up and down 3 inches. I still have room to cut the slots longer if I need it.
I will try to load photos below.
Dave A.
With the motor board I have a 6 inch setback and it will adjust up and down 3 inches. I still have room to cut the slots longer if I need it.
I will try to load photos below.
Dave A.