sand blasting/wood for decking

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

downtofish

Member
Joined
Dec 9, 2011
Messages
9
Reaction score
0
I wanted to blast a couple boats next weekend and was wondering what material was best/cheapest. Also What wood does everyone use for decking? I'm working on a 12 v hull starcraft, a 14 semi v flat bottom...neat boat, no clue on the make, and a 12 foot aluma craft Jon... two need paint, all three need decks. Thanx in advance for any help you could give me !!
 
I would be very careful blasting aliminum. Sand may be a little to coarse. Walnut hulls or some other soft media may be much better. Most here sand, wire brush or use scuffing pads.
Exterior grade plywood can be good if you are careful with selection.
 

Latest posts

Top