Drink holder for my Jon...

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

jmed999

Well-known member
Joined
Jan 18, 2012
Messages
56
Reaction score
0
Location
Aiken, SC
Here is a pic of my Jon boat...

Boat 6.jpg

I sit on the middle bench seat. What is a good way to mount a drink holder? The ones I've seen have a suction cup and I don't think those would work.

Thanks guys! :)
 
I use the seasense ones from Wal-Mart. They work great. I would just rivet one to the side of your bench.
https://www.walmart.com/ip/Seasense-Adjustable-Drink-Holder/16778799
 
Hole saw, and push in cop holder. Run some hose to the bottom of the cup holder, and route it so it drains into the bottom of the bilge.
 
jojo said:
I use the seasense ones from Wal-Mart. They work great. I would just rivet one to the side of your bench.
https://www.walmart.com/ip/Seasense-Adjustable-Drink-Holder/16778799

Just ordered 2 of these from Amazon...thanks!
 
I use small canvas bags that have clips on them. We used to use them on our climbing body belts to hold hardware. Maybe something like carpenters use on their belts. I just clip them on whatever is available at the time, like the oar locks, bench seat braces, etc.
 
BTW for any of you REALLY cheap skates, fullsize Ford Bronco's use the same cupholder, and it's mounted in the back panels beside the rear seat.

I've got a couple in the garage, I pulled at a PnP while getting a couple things for my Bronco. Cost me like a buck each or less.
 
Nice deal! I need to get a couple for my project and have been looking around for a steal on some.
 
Top