TinBoats.net
The original aluminum boat site!
Simple Seat Mounting?
- Thread starter Spongebob
- Start date
Help Support TinBoats.net:
muskiemike12
Well-known member
Sure, just put some big fender washers and lock washers on before the nut. I went a little over board with mine and used some flat stock aluminum as a back up plate. I have always used washers before and never had a problem.
MrSimon
Well-known member
Depends on the thickness and width of the bench, the length of the pedestal, and the size of the butt sitting in the seat :lol:
If you have easy access to the bottom of the seat, its best to put some sort of backer plate in there - the bigger the better.
If you don't have easy access .... well, just do your best and see what happens
If you have easy access to the bottom of the seat, its best to put some sort of backer plate in there - the bigger the better.
If you don't have easy access .... well, just do your best and see what happens
