How to install a drain plug in the bilge?

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Scotto53

New member
Joined
Mar 23, 2012
Messages
3
Reaction score
0
I bought an older v-hull that has no drain in the bilge. I need to install one. Is there some kit available to add one? Has anyone ever done this?

Thanks

Scott
 
I did one on my 12 ft that's a trailer queen.. I used a bilge pump through hull bulkhead and a 5/8" plug. Measure twice, drill once.
 
There are several drain plug kit available here are couple of pictures of what I think you are looking for. Heres a link also

https://www.iboats.com/Boat-Drain-Plugs/dm/view_id.257673
 

Attachments

  • full-831-693-drainplug.jpg
    full-831-693-drainplug.jpg
    7.2 KB · Views: 977
  • full-831-692-3160040c.jpg
    full-831-692-3160040c.jpg
    4 KB · Views: 977
fool4fish1226 said:
There are several drain plug kit available here are couple of pictures of what I think you are looking for. Heres a link also

https://www.iboats.com/Boat-Drain-Plugs/dm/view_id.257673
I am in the same boat, well um, sorry I had to say that... Anyway, I don't have a drain plug either and I asked a local marina if they could add one and they thought the metal might be too thin given the age, to weld a pipe in. My question is, would those plugs you have there work even if the metal was too thin for a pipe?
 
With either of the plug kits I would use some kind of backing plate. Drill the proper size hole and bolt/screw the kit to the outside of the boat with the backing plate on the inside. Be sure to seal everything with some 5200 or other good sealant.
 

Latest posts

Top