Bow Mount Trolling Motor Bracket

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

FishinsMyLife

Well-known member
Joined
Aug 10, 2007
Messages
1,546
Reaction score
0
Location
Lexington, SC
I don't want to mess around with screwing 2X4's together, so I'm going to get a bracket/platform made from aluminum.

photo-1.jpg



This is what I'm working with. I'm thinking about getting the fab shop to make a platform along the left side of the front deck flush with the top, just wide enough (4" or so, I'll have to break out the tape measure) for the motor to fit. I have a seat and passengert up front fairly often, so I gon't want to put it in the middle or take up any more space than necessary.

Not sure if I want it with a small "lip" so I can rivet/bolt it down or if I'll get them to weld it on.

Comment/criticisms?
 
Heres mine,probably he same as what your thinking.
Can't remember,I think I was charged around $30.
sydney and project 271.jpg
TM plate.jpg
 

Latest posts

Top