FishinsMyLife
Well-known member
I don't want to mess around with screwing 2X4's together, so I'm going to get a bracket/platform made from aluminum.
This is what I'm working with. I'm thinking about getting the fab shop to make a platform along the left side of the front deck flush with the top, just wide enough (4" or so, I'll have to break out the tape measure) for the motor to fit. I have a seat and passengert up front fairly often, so I gon't want to put it in the middle or take up any more space than necessary.
Not sure if I want it with a small "lip" so I can rivet/bolt it down or if I'll get them to weld it on.
Comment/criticisms?
This is what I'm working with. I'm thinking about getting the fab shop to make a platform along the left side of the front deck flush with the top, just wide enough (4" or so, I'll have to break out the tape measure) for the motor to fit. I have a seat and passengert up front fairly often, so I gon't want to put it in the middle or take up any more space than necessary.
Not sure if I want it with a small "lip" so I can rivet/bolt it down or if I'll get them to weld it on.
Comment/criticisms?