erictetterton
Well-known member
I put a plywood floor with carpet in a couple months ago and am pleased with how it turned out, but i found a deal on some old road signs and for $60 i can have an all aluminum floor in the boat and much less maintenance down the road.
here's the floor
i ripped out the plywood floor (wasn't screwed down) and am going to use it as a stencil. I would like your input on how you would go about piecing these signs together to make it look the best? Should i overlap the signs whole? cut them down to fit? i have foam between the ribs, as well as some rubber matting for support. I plan on putting rubber bike tire tube between the signs and the ribs to keep down on noise. i will rivet the signs down to the ribs for a nice clean look.
here's a pic of the signs laid out on top of the old floor, the best way i could come up with.
any input would be greatly appreciated
here's the floor
i ripped out the plywood floor (wasn't screwed down) and am going to use it as a stencil. I would like your input on how you would go about piecing these signs together to make it look the best? Should i overlap the signs whole? cut them down to fit? i have foam between the ribs, as well as some rubber matting for support. I plan on putting rubber bike tire tube between the signs and the ribs to keep down on noise. i will rivet the signs down to the ribs for a nice clean look.
here's a pic of the signs laid out on top of the old floor, the best way i could come up with.
any input would be greatly appreciated