I have a 14ft skiff with a 32 in wide bottom that i need to geta motor setup right. I have an old 7.5 merc that i put on it. When i test drove the combo i had a few issues. One is it seems like it is trimmed out too much. Its in the 1st hole(closest to transom) but it rode bow high an just looked trimmed out alot compared to others.. Idk if theres sn issue with the motor or what. Also i think the motor sets too low. I had spray coming like out the sides of the motor when i got some speed up. Boat is short transom as is motor. Cav plate was level with bottom of boat.. I jacked it up an inch w a block of wood an it still did it, but a little less. What yall think