I have a 6' piece of a piano hinge I need to cut to fit a project. Do I just whack it at the length I need? Not sure if I have to worry about the pin in the hinge coming out or something when I cut it.
TinBoats.net
The original aluminum boat site!
Cutting Piano Hinge
- Thread starter BigTerp
- Start date
Help Support TinBoats.net:
I have just cut them for several projects Never had the pin come out.
Thanks
rscottp
Well-known member
Pin shouldn't be an issue. Cut away!
if you really want to ensure the pin does not come out,
push the pin through a 1/4" and ding it closed on the end.
On the other end, pull the pin out 1/2" and cut it off then
push it back into the hinge and you can ding that end closed also.
But with just normal use, the pins don't come out. If they do,
just push it back in.
push the pin through a 1/4" and ding it closed on the end.
On the other end, pull the pin out 1/2" and cut it off then
push it back into the hinge and you can ding that end closed also.
But with just normal use, the pins don't come out. If they do,
just push it back in.
Thanks!!
I have it for my stern deck that I was suppose to put on 2 years ago. Not really much room for a deck back there with control cables, gas lines, etc. Might still end up putting one on though. I'm actually using the piano hinge to make a DIY compost tumbler.
I have it for my stern deck that I was suppose to put on 2 years ago. Not really much room for a deck back there with control cables, gas lines, etc. Might still end up putting one on though. I'm actually using the piano hinge to make a DIY compost tumbler.
lovedr79
Well-known member
Barefoot_Johnny said:
this is exactly what i did.
