1986 Alumacraft Trophy 170 Transom Rebuild

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Kit_B

Member
Joined
Jul 9, 2012
Messages
20
Reaction score
0
I just got done rebuilding the transom on my boat.
The motor hung in my garage for 8 days, while I went through the process of tearing it apart & putting it back together.
I tested the finished product & it put a smile on my face.
No leaks & strong as an ox.

Here are some photos...
 

Attachments

  • Trophy 170 - 1 Small.jpg
    Trophy 170 - 1 Small.jpg
    198.7 KB · Views: 491
  • Trophy 170 - 2 Small.jpg
    Trophy 170 - 2 Small.jpg
    209.9 KB · Views: 491
  • Aft3.jpg
    Aft3.jpg
    61.8 KB · Views: 491
  • Aft2.jpg
    Aft2.jpg
    75.1 KB · Views: 491
  • Aft1.jpg
    Aft1.jpg
    42.5 KB · Views: 491
  • Port1 - Small.jpg
    Port1 - Small.jpg
    36.8 KB · Views: 491
  • Starboard2 - Small.jpg
    Starboard2 - Small.jpg
    34.2 KB · Views: 491
  • 20160603_182537.jpg
    20160603_182537.jpg
    36.4 KB · Views: 491
  • New Board1 - Small.jpg
    New Board1 - Small.jpg
    32.6 KB · Views: 491
  • Transom Board - Small.jpg
    Transom Board - Small.jpg
    46.4 KB · Views: 491
To do the splashwell drains, I ordered aluminum tubes with a single flange & then I got some 5/8" hardware & some 1/2" tube fittings.
 

Attachments

  • Drain tube new flange.jpg
    Drain tube new flange.jpg
    11.5 KB · Views: 480
  • Drain tube factory flange.jpg
    Drain tube factory flange.jpg
    19.9 KB · Views: 480
  • Drain tube step 3.jpg
    Drain tube step 3.jpg
    23 KB · Views: 480
  • Drain tube step 2.jpg
    Drain tube step 2.jpg
    19.2 KB · Views: 480
  • Drain tube step 1.jpg
    Drain tube step 1.jpg
    26.5 KB · Views: 480

Latest posts

Top