3/16" Brazier Head rivet tool to set solid rivets $10 or $13

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

DaleH

Well-known member
TinBoats Supporter
Joined
Dec 12, 2014
Messages
3,582
Reaction score
399
Location
Eastern Mass
I know when I went looking for a tool head to fit an air hammer, I had to look high and low before I found one at a reasonable price - that was sold individually.

For the price of this one, even if someone just wanted to tighten up a few rivets here and these by hand, I'd think they could use a hammer against this tool (wear safety glasses please ... ) as a helper held the head of a heavier hammer or sledge up against the expanded (or to be expanded) rivet tail.

Ballpark ~ $10 + isn't a bad price at all! I recall I paid about $20 for the one I used in my Haba Freight rivet air hammer.

$10 - https://www.harryepstein.com/index.php/ajax-a1620-brazier-head-rivet-set-3-16.html?gclid=Cj0KEQjwh428BRCnvcyI-5nqjY4BEiQAijebwqW7Ib1BL_CBG6QhWTfULRRdUW1DLuyRv2aAbTM14UkaAu538P8HAQ

$13 - https://www.autobodydepot.com/AJX-A1620_2.html#.V4P1dvkrJDM
 

Attachments

  • 3-16 Brazier Head Rivet Tool.jpg
    3-16 Brazier Head Rivet Tool.jpg
    14.7 KB · Views: 1,483
FYI, got some PMs about rivet tools for use with air hammers and this is the $20 bucking tool I used to install my new transom pieces. I'm sure there are other sources too ... besides just using a suitable block of steel, LOL!

https://www.vintagetrailersupply.com/Bucking-Bar-p/vts-825.htm
 

Attachments

  • Buck-Bar.jpg
    Buck-Bar.jpg
    20.5 KB · Views: 1,397

Latest posts

Top