Hi
I am new to Tin Boats and have been following and learning from the forums and would appreciate your advice. Am putting an Alweld 1648 VV LA 21” transom with a 25 Hp Mercury 2 stoke long shaft remote steer. Have purchase a Vance 4” setbackbac manual jack Plate and would like to use this with my Neptune trim and tilt. This would result in a total setback of 11”. Will this be too much?
Thanks so much
I am new to Tin Boats and have been following and learning from the forums and would appreciate your advice. Am putting an Alweld 1648 VV LA 21” transom with a 25 Hp Mercury 2 stoke long shaft remote steer. Have purchase a Vance 4” setbackbac manual jack Plate and would like to use this with my Neptune trim and tilt. This would result in a total setback of 11”. Will this be too much?
Thanks so much