Did some searching and came up empty. Lots of help in how to install, but nothing on what you go by for leveling a floor between bench seats.
When cutting braces and standoffs that the floor will set on, what in the boat do you measure or level off of?
Do you use the rail tops as the point of reference and measure down equally? Use the hull bottom and measure up? Measure down equally from seat tops? Position boat on trailer so the rail tops are level and then make floor level?
A boat will set a bit higher in the front, so leveling with the hull bottom may not allow for a level floor when on the water.
Maybe this is not a critical issue.
When cutting braces and standoffs that the floor will set on, what in the boat do you measure or level off of?
Do you use the rail tops as the point of reference and measure down equally? Use the hull bottom and measure up? Measure down equally from seat tops? Position boat on trailer so the rail tops are level and then make floor level?
A boat will set a bit higher in the front, so leveling with the hull bottom may not allow for a level floor when on the water.
Maybe this is not a critical issue.