adam_mac84
Active member
- Joined
- Sep 12, 2018
- Messages
- 34
- Reaction score
- 1
I am rehabbing a 74 Sea Nymph 14b.
Took off wood transom support to replace. Noticed the wood (placed by PO, Not factory) does not fit a small indent that seems stock. Just to confirm. Should I try to fit the transom board to this indent? Common sense would say yes. PO places a 20” 1.5” board across the whole back.
The issue is that water seems to have been getting up behind there.
I tried to mark the area for better visual contrast for photo. Also pictured is removed transom board. (Blue is indent in aluminum. Yellow is where board I removed was placed)
Sent from my iPhone using Tapatalk
Took off wood transom support to replace. Noticed the wood (placed by PO, Not factory) does not fit a small indent that seems stock. Just to confirm. Should I try to fit the transom board to this indent? Common sense would say yes. PO places a 20” 1.5” board across the whole back.
The issue is that water seems to have been getting up behind there.
I tried to mark the area for better visual contrast for photo. Also pictured is removed transom board. (Blue is indent in aluminum. Yellow is where board I removed was placed)
Sent from my iPhone using Tapatalk