basenjib123
Active member
Anyone know where I can get some spacers (bushings) with 1/2" ID x 1" OD x 1"L ?? Doesn't really matter what material they are made of. I cannot find anything online. Thanks.
TinBoats.net
The original aluminum boat site!
Source for a spacer?
- Thread starter basenjib123
- Start date
Help Support TinBoats.net:
maintenanceguy
Well-known member
https://www.mcmaster.com/spacers/length~1/od~1/id~1-2/
I have some 1" thick HDPE (thick cutting board material) and could make some if needed ...
Colorado1135
Well-known member
have you looked at an implement dealer? I would think there are some 3 point bushings that would fit or get you real close.
gogittum
Well-known member
I found some smaller ones for the rusted out keel roller bushings on my boat trailer on eBay. Did a search for "trailer wheel bushings."
basenjib123
Active member
Thank you for the replies..Joe.
