TinBoats.net
The original aluminum boat site!
trolling motor
- Thread starter fishsalot
- Start date
Help Support TinBoats.net:
Captain Ahab
Well-known member
BassNBob
Well-known member
Here is something to think about and you can make it out of wood or steel. I've added a pic of the T/M so you can see how the head has been reversed in order to fit the front of the boat. There is a small screw that you need to remove, rotate the hear and instal the screw back like Bubba said. Hope this helps.
Attachments
Loggerhead Mike
Well-known member
i beleave its because your motors backerds when mounted on the front
Bubba
Well-known member
You have to loosen the 'head" of the trolling motor and turn it around. I've never done it, but from what i've heard there is usually a screw that holds the head onto the shaft, loosen/remove that screw, twist the head around 180 degrees, then tighten the screw back down.
