TinBoats.net
The original aluminum boat site!
Where can I order these bolt
- Thread starter Trinity
- Start date
Help Support TinBoats.net:
I think their discontinued but dealers still have them as NOS. They are pricey. At least $30 each new. Check ebay for used transom screws. Check here for new screws: https://shop.evinrude.com/
You can buy allen head studs at hardware stores the same size and then buy a stout cupped washer with a hole just small enough so the bolt doesn't push through. My motor is set up like this because my clamps were getting in the way of my jackplate when I would slide it down. The allen head screws makes it harder to steal the motor since very few thieves are carrying around a big allen wrench.
You can buy allen head studs at hardware stores the same size and then buy a stout cupped washer with a hole just small enough so the bolt doesn't push through. My motor is set up like this because my clamps were getting in the way of my jackplate when I would slide it down. The allen head screws makes it harder to steal the motor since very few thieves are carrying around a big allen wrench.
If your handles are good yet the threaded part can be made with threaded rod & some craftmanship.
Trinity
Well-known member
Good thing my Neighbor knows everything and drilled the bolts out and re-tap the threads. I needed to buy a 5/8-11 threaded rod and he hooked it on up. with a handy neighbor it cost me $5 for the complete fix.
