TinBoats.net
The original aluminum boat site!
Pressure tank question?????
- Thread starter Spook
- Start date
Help Support TinBoats.net:
cajuncook1
Well-known member
- Joined
- Mar 24, 2010
- Messages
- 437
- Reaction score
- 1
I promise you, the authorities on pressure tanks would be the AOMCI website.
BassBlaster
Well-known member
I dont know the correct answer to this question but I can tell you I replaced the top gasket and the gaskets on the screws and I didnt use any sealant. Its not leaking yet.
- Joined
- May 15, 2010
- Messages
- 3,667
- Reaction score
- 325
- Location
- Central Florida
- LOCATION
- Lake County, Central Florida
Your statement is a little vague. When you do a pressure tank you need to replace the diaphragm, the gasket and the seals on each individual attachment screw. The latter can be nothing more than plastic washers purchased through a hardware store. The answer is no on the need for a sealer. When used, the sealer will often allow the gasket to migrate or slide while tightening the fasteners.
