1975 johnson seahorse 25hp high idle neutral

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

mangelcc

Well-known member
Joined
Nov 1, 2009
Messages
230
Reaction score
0
Location
Kinston NC
Anyone ever ran into this. Sync and link procedure? Its a buddy of mines motor, it cranks first pull but revs very high in neutral. Put motor in gear and its fine. any ideas? Thanks
 
On the top of the carb at the rear of it you will find a roller. That roller runs on a cam on the bottom side of the mag plate. On that plate there is an alignment mark that is there to indicate the pick up point for the roller and therefore the carb opening. Re-adjust the linkage to allow the carb to remain closed until the mag is rotated and the mark lines up with the roller.
 

Latest posts

Top