johnson fuel line routing

quick question i have a 84 johnson 15 horse, when i bought the motor i needed some work i replaced the fuel pump etc... it didint have the fuel line from the connector to the pump it just ran it around the back of the motor. obviuosly this is wrong because i can get it to fit with the cover.... so whats the best way to run this ?
thanks
!

I have an '83 Evinrude 15 that I just replaced this line on this year. My line was routed from the connecter, down around the port side of the motor.(Follow along the inside of the pan.) Underneath the t-stat cover/head at rear of motor by the hood latch.(tight fit here!) and then back around the starboard side up to the fuel pump. Hope this helps!

had the same problem with my 1979 25hp .....
Starting with a NEW fuel line (because it is more flexible)
run it however it fits into the nooks and crevices without kinking or binding anything.
Adjust the fuel pump nipples that will fit the new configuration
and allow easy opening/closeing of the hose clamps.
- - - ZipTie it in place - - -
Get a hose that is longer than needed so you can trim it to fit
AFTER it is all set in place.
As long as you are doing fuel lines, it would be a good idea to do ALL of them.
jusayin





There is nothing more grand than to be simply
just messing around in a boat - POGO, 1960