Need mechanic

Xpress_442 · Nov 6, 2012

Hey guys, recently my tilt and trim seals went out. Naturally I replaced them filled it back up and bled it. Now it will only go half way up before it stops. I don't know what the problem is I put as much fluid as would fit and it won't work. Any ideas?

lovedr79 · Nov 6, 2012

May have to bleed air out. May even have to reset the ram by unscrewing a bolt raise the motor by hand and re tighten to set the range. Not sure how its done exactly.

Pappy · Nov 7, 2012

You will have to fill it a second time at the very least. When extended to its full capability fill it again. No big deal and very normal.

Xpress_442 · Nov 7, 2012

Thanks for the info guys I was at a loss. I'm gonna get some more fluid on my way home and try and fill it again

Xpress_442 · Nov 7, 2012

Got it fixed!!!! Thanks for the help guys I wasn't bleeding it right and it needed waaay more fluid

lovedr79 · Nov 7, 2012

Glad u got it done

Need mechanic

Help Support TinBoats.net:

Xpress_442

Well-known member

lovedr79

Well-known member

Pappy

Well-known member

Xpress_442

Well-known member

Xpress_442

Well-known member

lovedr79

Well-known member

Similar threads

Latest posts

Need mechanic

Help Support TinBoats.net:

Xpress_442

Well-known member

lovedr79

Well-known member

Pappy

Well-known member

Xpress_442

Well-known member

Xpress_442

Well-known member

lovedr79

Well-known member

Similar threads

Latest posts

Join the conversation!

Join today and get all the highlights of this community direct to your inbox. It's FREE!