See photo.
Also, any tips on how to hold the lower unit in a vise to drill out the sheared off machine screw? Assuming originals were stainless-these were not...head on one was nearly gone, filed it off, then managed to shear off the stub...not enough heat, time or just bum luck. Hand impact worked well on the other 3 at least.
Also, any tips on how to hold the lower unit in a vise to drill out the sheared off machine screw? Assuming originals were stainless-these were not...head on one was nearly gone, filed it off, then managed to shear off the stub...not enough heat, time or just bum luck. Hand impact worked well on the other 3 at least.