Minkota Endura 50 rebuild

MrT · Jan 7, 2016

Found a 2007 Endura 50 (2007) that someone didn't want because they couldn't get any power from it. After a good look over I found that the axle in the assembly was bent and was causing a real bad vibration.

I was pleased to find out all the parts needed I could get from Minkota and only cost $66! Here's to hoping this rebuild will get that thing functioning again.

user 20022 · Jan 7, 2016

Subscribed.

Sent from the dust in front of you!

MrT · Jan 14, 2016

Parts came in...

Install was quick...

Works like a charm!!! Now it's time to get a boat [emoji6]

user 20022 · Jan 14, 2016

Awesome!

Sent from the dust in front of you!

Jim · Jan 15, 2016

Nice job! Do you have any side by side shots of the bent shaft and the new one?

MrT · Jan 23, 2016

Jim...I don't but could pretty easily. If it would help the group I can take it back apart.

MrT · Jan 23, 2016

It's kinda hard to tell but the left side is slightly bent where the pin insert is. This was causing crazy vibration at higher speeds.

richg99 · Jan 24, 2016

Well done.

Wonder how many Garage Sale finds like that are out there? This post will give a lot of guys ideas.

Thanks, richg99

Minkota Endura 50 rebuild

Help Support TinBoats.net:

MrT

Member

user 20022

Well-known member

MrT

Member

user 20022

Well-known member

Jim

Well-known member

MrT

Member

MrT

Member

richg99

Well-known member

Similar threads

Latest posts

Minkota Endura 50 rebuild

Help Support TinBoats.net:

Member

Well-known member

Member

Well-known member

Well-known member

Member

Member

Well-known member

Similar threads

Join the conversation!

Join today and get all the highlights of this community direct to your inbox. It's FREE!