Mod V jet foot height

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

rktman

Well-known member
Joined
May 23, 2013
Messages
89
Reaction score
0
I bought an older Alumacraft 15x48 with a slight V (about 1.5" in the middle). It has a 40 hp jet on it and I think the foot is a bit low. What is the rule of thumb for these mod V setups? I'm used to a flat bottom that you can just straight edge to middle of the first grate pin.
Thanks.
 
You're just gonna have to go through the setup process with a jet like every other hull. My experience is you can go a little higher than a straight edge to the front grate pin but that is on a mod-v with no center keel (Grizzly).
 

Latest posts

Top