Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Trolling motors, Fish Finders, GPS, Batteries, anything Electrical, post it here.
2 posts • Page 1 of 1
- Posts: 36
- Joined: 05 Dec 2014, 15:33
- Location: Stone Mountain Georgia
I am trying to use a tp link router ,with a lowrance Ethernet cable that I cut one end off and installed rj45 connector on, to make my lowrance hds 10 gen 2 wifi to a tablet. Somehow I think that I assigned the hds 10 ip address to port 1 of the lowrance module box (that is where Ethernet cable is connected ). in retrospect I think this was a mistake and now I think the ip address should be assigned back to hds10 , as it was originally. I cant figure out how to assign ip back to hds. when I look in settings is says ip address not available. any info would be appreciated.
- Site Admin
- Posts: 18224
- Joined: 29 Nov 2006, 21:00
- Location: Shrewsbury, MA