richg99
Well-known member
I have a pump that uses sensors
https://smile.amazon.com/Johnson-Pumps-32-47260-003-Ultima-Bilge/dp/B000RZR2QI/ref=sr_1_12?crid=1SAU30SW527I8&keywords=johnson+bilge+pump&qid=1557008414&s=gateway&sprefix=johnson+bilge+pump%2Caps%2C191&sr=8-12
To check it, can I just short out the two sensors with a wire? or must I fill the bilge with water? This assumes that the sensors are clean, of course.
https://smile.amazon.com/Johnson-Pumps-32-47260-003-Ultima-Bilge/dp/B000RZR2QI/ref=sr_1_12?crid=1SAU30SW527I8&keywords=johnson+bilge+pump&qid=1557008414&s=gateway&sprefix=johnson+bilge+pump%2Caps%2C191&sr=8-12
To check it, can I just short out the two sensors with a wire? or must I fill the bilge with water? This assumes that the sensors are clean, of course.