1992 Polar Kraft MVT-1751 with a 1992 Evinrude 60 HP…my first tin boat project

[Axhammer]

Aye Capt’n … Steady as she goes

I’m sure Thill has read this thread, because he has commented along the way.

After studying the pic I posted more, I believe I can simply raise the assembly until the roller sits under the eye fitting. That will raise the winch making a straighter pull.

It’s free to loosen the nuts and try a different position, so that’s what I’ll try.

On another note. Should the transom be lined up with the end of the bunks? Or is it ok to have the back of the boat past the ends of the bunks a few inches? Right now the transom is even with the bunks.

 

[LDUBS]

Aye Capt’n … Steady as she goes

I’m sure Thill has read this thread, because he has commented along the way.

After studying the pic I posted more, I believe I can simply raise the assembly until the roller sits under the eye fitting. That will raise the winch making a straighter pull.

It’s free to loosen the nuts and try a different position, so that’s what I’ll try.

On another note. Should the transom be lined up with the end of the bunks? Or is it ok to have the back of the boat past the ends of the bunks a few inches? Right now the transom is even with the bunks.

The transom should be 100% supported by the bunks. The transom should not hang past the end the bunks. It is very normal for the bunks to extend 1/2' - 1" beyond the transom. I would shift the bunks back an inch.

 

[Axhammer]

My wife has been sick & hospitalized since December 26th. I haven’t had time to do anything for the last four months. I decided to start making time to work on this boat, otherwise it will never get done.

Yesterday I started sanding, inspecting and preparing the interior so I can paint it. After I have painted it, I want to get the rib reinforcement angles permanently riveted/bonded to the ribs, that will support the floor sheet I cut previously.

I spent about four hours sanding, another hour or two cleaning and wiping everything with acetone. It was kind of a tedious job, but I got it done and applied a coat of paint last night. It took another hour at least to paint it, again, it was a tedious lob, but now it is done and ready for the next step.

 

[LDUBS]

I'm sorry to hear about your wife and hope she feels better soon.

The boat is looking great. It would have taken me a lot longer than a day or two to accomplish that. Nicely done.