Recent content by Daretofish

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Daretofish

    Source for Johnson 9.9/15 tiller handle ruber cover 1980s

    It's just the rectangular rubber piece covering the pivot point. I will order it from nymarine.
  2. Daretofish

    Source for Johnson 9.9/15 tiller handle ruber cover 1980s

    Good news! nymarine.ca has it. Thanks Pappy! https://nymarine.ca/grommets.htm
  3. Daretofish

    Source for Johnson 9.9/15 tiller handle ruber cover 1980s

    I will check nymarine. thanks Foot, let me know. That's an old one though.
  4. Daretofish

    Source for Johnson 9.9/15 tiller handle ruber cover 1980s

    Hello, does anyone know of a source for these, they seem to be discontinued bt OMC. part number 23
  5. Daretofish

    2 HP Johnson lower unit install

    Well, after a few beers, talking to it nice, and some wiggling, it went together! thank you Johnny for the diagram, I think it helped!
  6. Daretofish

    2 HP Johnson lower unit install

    It's the driveshaft from the head to the lower unit that came out of the lower unit. It should come out of the head, or, bottom of crankshaft. So with the shaft out of the lower unit the gear looks like it could get out of alignment. I'm trying to get the lower back on, so the drive shaft has to...
  7. Daretofish

    Questions re: breaking in new 8-HP Tohatsu

    Good excuse to go out for a long ride! The good thing about always buying used, no break-in!
  8. Daretofish

    2 HP Johnson lower unit install

    Thank you for that Johnny, do you think the gear (part 7) is not aligned?
  9. Daretofish

    2 HP Johnson lower unit install

    Hello, I just picked up a 1985 2HP Johnson, previous owner took out the water pump impeller, I just wanted to put it back in as I don't intend to use it. So the driveshaft is stuck in the powerhead and came out of the lower, now it wont go back together. It lacks about 1/2", apparently the...
  10. Daretofish

    1981 4hp evinrude outboard

    I have the 1988 Johnson version, twin cylinder, it has the spot for the gas tank to mount on the rear. Only has forward and neutral. It actually planes a 12' aluminum with just me and the gas tank up forward.
  11. Daretofish

    Update: Johnson 15hp power pack coil question

    Thanks for the information Fordman, I believe I have this one running as good as it can be expected. It has the recommended Champion plugs. and is pushing a 12' V aluminum to 24-25 MPH with just me.
  12. Daretofish

    Help with 1988 Johnson 25!!

    The fuel pump can leak fuel into the crankcase if diaphragm is ruptured, might check that.
  13. Daretofish

    Help with 1988 Johnson 25!!

    What oil did you use? the penzoil semi-synthetic I use burns very clean-little smoke for old two strokes.
  14. Daretofish

    Evinrude 15 not very fast

    Make sure throttle is wide open. years ago we got a new to us 25hp, 1st few times out I thought it was slower than our old one, found out the twist grip went to a point then got harder to turn. Going past that was wide open, and fast!
  15. Daretofish

    Update: Johnson 15hp power pack coil question

    Hello Charger, did you ever figure yours out?
Top