Recent content by skunkstripe

Lol that was great.

So sorry have you in our prayers

Oh thanks for the advise I really was wanting to try to get away from the rollers. This is my first vee bottom boat. Those little rollers are a pain to line up with when you're trying to load it. My other boat was a 14 foot flat bottom and the trailer had bunks easy to load. Any way was...

Ok I think I posted this question in the wrong place. If I can figure out how to move it I'll move it to the trailer part of the forum. Sorry for the mistake.

Ok here's my question. I have rollers on my trailer and would like to switch to bunks. The boat when it sits on the trailer. Is supported by 3 rollers down the middle. And 2 small 2x4 in the rear. My question is does it have to be supported by the runner down the middle or can it be supported...

Here is a pick of the sea nymph name on the side of the boat. Just trying to find out general information thanks.

Here is my question. I got a good deal on a 1979 12foot sea nymph aluminum boat. Striped it down. Cleaned her up changed out some old wood. Any way here is my question, I know its a sea nymph because it is on the side of the boat. But the metal plate inside the boat is long time gone. When I go...

Finally figured out how to post pics. Before and after

Here is a pick of the boat any help will be appreciated thanks

Ok here's my question. I have a 1979 12 foot sea nymph Semi vee aluminum boat. But I can't find any information about this boat. When I search the net. It says sea nymph was manufactured by the lowe company, but when I go to iboats or do a search on the net there is no listing for a 12foot sea...

Thanks everyone

Hay thanks everyone lot of good advice. One more question. My boat before this was a 9ft plastic buster boat. I put a honda 2hp 4 stroke outboard on it. The little motor pushed the boat fairly good, not going to break no speed records. But it got me where I wanted to go. How do you think it...

Hay thanks seminole county here never heard of spar. Can it be picked up at ace or lows.thanks again

Thanks I think I will use it like it is until summer. Just a couple of months. When it gets to hot to fish I will pull the lumber off. And replace with untreated wood. Marine lumber to expensive and to hard to come by. Any thoughts on how to treat the untreated lumber.i was thinking maybe...

Ok I'm new to the site from oklahoma. Just got a good deal on a 1979 12ft sea nymph. the paint was pretty bad when I got it, so I cleaned her up. Pulled the seats. Ruffed up the old paint. Primed and painted. Put the seats back. Put a treated 2x12 on top of the bench seats to mount swivel...